11 May 10 Ceiling installation process for a surround sound system

Determine first obligation to use: Before you begin installation, you should be clear how you intend to use from the ceiling. What if you use the speakers in the dining room will be used as background music for parties, so it is best to install ceiling speakers around your room.

With the second tape measure to ensure that the speakers in the room evenly. You can mark the spot with a pencil.

Use the first third stud finderCut your ceiling to make sure they do not encounter any obstacle

Fourth center cutting templates (which was dealt with speakers) for the position of each speaker from the ceiling and mark a page with a pencil. Drill a small hole in the center of the drawing.

Fifth take the next hook. Bent at an angle of 90 degrees, about 6 cm from the end. Insert the tip into the hole in the wall of the fact until you turn 90 ° turn and the wire to verifythe area within the structure contains no disability o. If found no obstacle, remove the bracket saw and trim the edges with drywall.

Sixth Prepare a plan to put the speaker wires

Seventh Use fish tape to pull wire hole to access your speaker hole receiver, where they are.

Eighth caution when connecting the cable.

Close recommended the installation of the ninth came with the speaker of the ceiling

Followthese simple steps to install ceiling speakers without any problems.

Tags: Battery, ceiling, DSLR-A850Q, Installation, NP-FM500H, process, replacement, surround, system